Residential and commercial
We install standing seam and other metal panel roofs, fastened to move with the heat. Houses and commercial buildings, quoted in full before we start.
Free, no-obligation estimates. We answer Monday to Saturday, 8 am to 9 pm, and return later calls the next working morning.
Seams closed after the panels are set
Every metal roof job
What we hold ourselves to
Standing seam, ridge cap
What the work involves
A metal roof here is standing seam or another metal panel, fastened so it can grow and shrink with the heat. We put them on residential and commercial roofs alike, from a house to a business building.
The old covering comes off, the deck underneath is checked, and the panels go on over a new underlayment with new flashing at the edges, walls and vents. What separates a metal roof that stays tight from one that starts to leak is how the panels are fastened: they have to be held down without being pinned so hard that the sun pulls against them.
On the call, tell us what the roof is now and what you want it to be. We will say which panel suits it and quote the whole job before we start.
Most metal roofs are one of these panel types, and the difference is where the fasteners go.
"Standing seam"
Continuous panels run from the ridge to the eave, and the fasteners sit hidden under the raised seams.
"5V crimp"
The panel is screwed straight through its face, so the fasteners are the ones you can see from the ground.
How it runs
A metal roof job runs from the phone call and a free estimate, through a written quote for the whole job, to the panels set, seamed and cleaned up after.
We answer the phone or call you back the same working day, Monday to Saturday, 8 am to 9 pm.
We come out when we say we will and measure the roof the way roofers price it, by the "square", which is 100 square feet of roof surface.
Panel, trim, flashing and the unit price for any deck repair nobody can see yet, written down before we start, with no surprise charges after.
Standing seam panels can be roll-formed on the job site. They are fastened so the metal can move with the heat, and the seams are closed with a seaming tool once the panels are in place.
The old roof and the offcuts go, and we clean up when the work is done.
Cool roofs
A metal roof is not automatically a cool roof: its finish and color decide whether it is one. How much sun the roof throws back and how well it lets go of the heat it does take in come from the coating, not from the metal under it.
Not a cool roof.
Decide it.
Roofers call those properties "reflectance" and "emittance", and they are the words to ask about when you pick a color. The U.S. Department of Energy publishes cool-roof guidance that explains both.
What it costs
Metal roofing in Pompano Beach typically runs $6 to $12 a square foot installed, or $6,800 to $42,600 for a whole roof. Those are the published ranges for the area, not our quote; your number comes from measuring your roof.
Roofers price by the "square", 100 square feet of roof surface. The square count follows the roof, not the floor plan, because pitch, hips and valleys add surface beyond the footprint of the house.
From there the price moves with the panel system, the pitch, access to the roof, the condition of the old roof and any decking repairs found under it. Damaged decking is the usual hidden cost, so a good written quote prices deck repair by the unit before anyone climbs up.
$6 to $12 / sq ft
Installed. Standing seam sits toward the upper part of that span, with published rates in the city starting around $10 a square foot.
Free and no obligation. We quote the whole job before we start, with no surprise charges after.
Tell us about the roof and the building, and we will come out for a free, no-obligation estimate.
Standing seam or screw-down, on a house or a commercial building, the whole job is quoted before we start.
Call for a Free EstimateWe show up when we say we will, and we clean up when the work is done.
